Recent content by RoadExplorer1

I use a BAKFlip mx 4. The clamps sit over the rails and create their own seal.

I think it is a load resistor issue. Try installing 50-ohm load resistors in parallel with each taillight.

Hello everyone! Do you have any official starting dates for the Rev's production?

I am following this post. I hope my car is ok...

Hey, guys! The issue was related to the Rambox. There is a cargo outlet in there. I didn’t realize it was connected to the error message. I had to toggle off the switch on the dash below the headlight control (thanks @extremeDriver911). The error message is now gone, and everything’s working...

Hello! Has anyone else questioned the 400V to 800V conversion in electric motors after reading Mopar's article? I don't think there is anything great about the efficiency loss and the added energy cost. I don't understand how the 800V conversion from 400V would speed up charging. To me, it...

Why would it mess with the production?

Simple: use WAZE!!

Try a reset to defaults and see what happens.

Hey all! I don't know if you have read this, but it seems Stellantis is making a huge investment in three Michigan plants. To be more specific, it is about $406 million. They are looking to increase the EV and hybrid production, and the best part is it includes the upcoming Ram 1500 REV and Ram...

Yes, exactly! 2019 Laramie is a nice car, though!

Ups! I think you got more than a hole. You got a lesson as well. 😅

Hey, guys! I appreciate all of your replies. I will ask for an expert opinion and see what I have to do.

What model and trim level do you have? I am asking this because those loops might be connected to the reclining feature. Some trims or mods allow the rear seats to recline slightly, and those straps could play a role in that setup. If your model doesn’t have reclining seats, they might just be...

I appreciate it! Thank you. I will check them out. Why did you have to choose the fastener?